Cura Install GuideRecommended Printer Start G-Code
This G-Code will add a purge line to the start of each slicer job, preventing any excess filament from getting stuck on the bed, or first layer of the print.
G28 ;Home
G1 Z15.0 F6000 ;Move the platform down 15mm
G92 E0 ;Prime the extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish
G92 E0
G1 F200 E3
G92 E0
